期刊名称：ACTA SCIENTIARUM-TECHNOLOGY
 期刊简介(About the journal)
投稿须知(Instructions to Authors)
编辑部信息(Editorial Board)
About the journal
Acta Scientiarum. Technology. ISSN 1806-2563 (print) and ISSN 1807-8664 (on-line). The journal publishes original articles in all areas of Technology, including: Engineering, Physics, Chemistry, Mathematics, Statistics, Geo-science and Computer Science.
Impact factor (JCR 2010): 0,150
Aims: To establish the public inscription of knowledge and its preservation; To publish results of research comprising ideas and new scientific suggestions; To publicize worldwide information and knowledge produced by the scientific community; To speech the process of scientific communication in Technology.
Indexed in: ISI Web of Knowledge, JCR-Journal Citation Report, SCOPUS, Abstract Journal, Chemical Abstracts, Biological Abstracts, CAB Abstracts, EMBASE (Excerpta Medica), Periodica, Ulrich´s International Periodical Directory, Zentralblatt Math, Academic One File-Gale Cengage Learning, Informe Acadêmico-Gale Cengage Learning, Oaister, Latindex, BASE-Bielefeld and DOAJ.
Instructions to Authors
1. Acta Scientiarum. Technology, ISSN 1806-2563 (print) and ISSN 1807-8664 (on-line) is published four times a year by the State University of Maringá, Maringá, Paraná, Brazil.
2. The journal publishes original articles in all areas of Technology, including: Engineerings, Physics, Chemistry, Mathematics, Statistics, Geociências and Ciência of the Computation.
3. Author(s) should state that the manuscript, reporting original work, was not sent, in part or in whole, for publication to another scientific journal. This statement may be found at down.
4. Data, concepts, opinions and the preciseness of works cited are the author’s/ authors’ entire responsibility. Mention of products and commercial trademarks do not imply in any recommendation for use by the journal’s editorial board.
5. Research should be based on the most advanced and state-of-the-art techniques. When necessary, a declaration of the institution’s Ethic and Bio-security Board should be attached.
6. Articles should be written in English.
7. Articles will be reviewed by three peers acknowledged for their scientific production and research, from higher institutions in Brazil and abroad. After the necessary corrections and possible suggestions, the paper shall be accepted if two peers give a favorable statement; the article will be rejected if two peer reviews are unfavorable.
8. Articles are to be sent via Internet through the Portal ACTA.
9. Conflict of interests may be personal, commercial, political, academic or financial. Conflict of interests occurs when authors, revisors or editors have vested interests that may affect the writing or the evaluation of unpublished papers.
Authors are requested that on submitting a paper for possible publication they should acknowledge or disclose financial conflicts or others that may have affected their scientific work. Authors should identify all financial funding given during the execution of their work and other personal bonds with regard to the above. The revisor should inform the editors on any conflict of interests that may influence the manuscript's analysis and should declare him/herself ineligible for this particular task.
10. As from 2010 authors are accountable for its translation into a english language. Text translation should be paid for by the authors to the authorized revisors who will forward a certificate to this end.
11. Formatting and conventions are listed below:
a) On submission the full name(s) of the author(s) (six at the most), her/his/their institutional address(es) and the e-mail of the author for correspondence should be inserted.
b) Articles should be subdivided into the following subtitles (in bold and unnumbered): Abstracts and Key Words in Portuguese and English; Introduction, Material and methods, Results and discussion, Conclusion, Acknowledgements (Optional) and References.
c) The title, up to twenty words, in English, must be to the point. A Running Title, up to six words, is also mandatory.
d) Abstracts in Portuguese and English, up to 200 words, shall contain brief information on the aims of the research, experimental material, methods employed, results and conclusion. Key words, up to six, in Portuguese and English, shall be added at the end of the abstracts and should not include words found in the title.
e) Articles should not be longer than 15 pages, including figures, tables and bibliographical references, 1.5 line spacing, Times New Roman 12, numbered pages and lines, in MS-Word, or compatible.
f) Paper format should be A4 paper, with all page margins at 2.5 cm.
g) File containing the article to be transferred during submission should not exceed 2MB, and should have no identification label of the author, including in the option properties of Word.
h) Tables, Figures and Graphs shall be inserted within the text, immediately after being cited.
i) Figures and Tables should be preferentially 7.65 cm wide, not exceeding 16 cm.
j) Digitalized Figures should have a 300 dpi resolution and recorded in jpg. Colored illustrations will not be accepted.
k) The International Measurement System is mandatory.
l) Equations should be in software compatible to text editor.
m) Variables should be identified after the equation.
n) Review of articles will be published when authors are invited by the Editorial Board or by the Chief Editor of Eduem.
o) Editorial Board recommends that eighty per cent (80%) of the bibliographical references should be from articles listed at ISI Web of Knowledge or Scopus during the last 10 years. Quotes from international reviews and journals are also recommended. Citations from theses, dissertations, monographs, proceedings, abstracts, expanded summaries, newspapers, magazines, technical bulletins and electronic documents will not be accepted.
p) This citations or Works Cited should be placed in alphabetical order, based on the Brazilian Association for Technical Rules (ABNT), following examples below. For in-text quotes, use surname and year: Cowie (2001) or (COWIE, 2001); for two authors, use Costa Júnior e Mansur or (COSTA JÚNIOR; MANSUR, 2008); tree authors or more, utilize the first and et al. (MARTÍN et al. 2008).
REFERENCE MODELS
References should be listed in alphabetic order and justified, according to the examples below, based on the Brazilian Association for Technical Rules (ABNT). Titles of reviews should not be abbreviated but given in full, without by place of publication.
Articles
MARTÍN, M.; MONTES, F. J.; GALÁN, M. A. On the contribution of the scales of mixing to the oxygen transfer in stirred tanks. Chemical Engineering Journal, v. 145, n. 2, p. 232-241, 2008.
COSTA JÚNIOR, E. S.; MANSUR, H. S. Preparação e caracterização de blendas de quitosana/poli (álcool vinílico) reticuladas quimicamente com glutaraldeído para aplicação em engenharia de tecido. Química Nova, v. 31, n. 6, p. 1460-1466, 2008.
GROTTA, D. C. C.; LOPES, A.; FURLANI, C. E. A.; SILVA, R. P.; REIS, G. N.; CORTEZ, J. W. Biodiesel etílico filtrado de óleo residual de soja: desempenho de um trator agrícola na operação de gradagem. Acta Scientiarum. Technology, v. 30, n. 2, p. 135-138, 2008.
Books
COWIE, J. M. G. Polymers: chemistry and physics of modern materials. Cheltenham: Nelson Thornes: Chapman & Hall, 2001.
EL-REWINI, H.; ABD-EL-BARR, M. Advanced computer architecture and parallel processing. Hoboken: John Wiley & Sons, 2005.
SCHMAL, M. Engenharia das reações químicas e catálise. In: MELO JÚNIOR, P. A. Fronteiras da Engenharia Química I. Rio de Janeiro: E-papers, 2005. p. 21-50.
Submission Preparation Checklist
As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.
The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
The submission file is in Microsoft Word, RTF, or WordPerfect document file format.
Where available, URLs for the references have been provided.
The text is single-spaced; uses a 12-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.
Please indicate five peers (names and e-mail addresses) within the space "Comments to the Editor" below
Articles is in English
Instructions to Authors
AUTOR.pdf
Editorial Board
Eduem Director
Ivanor Nunes do Prado, UEM, Maringá, Paraná, Brazil
Editor-in-chief
Alessandro de Lucca e Braccini, UEM, Maringá, Paraná, Brazil
Sub-Editors
Nilson Evelázio de Souza, Editor - UEM, Maringá, Paraná, Brazil
Adley Forti Rubira, Editor - UEM, Maringá, Brazil
Nehemias Curvelo Pereira, Editor - UEM, Maringá, Brazil
Editorial Board
Alain Dechambrier, Département des Invertébrés, Muséum d’histoire naturelle, Geneva, Switzerland
Alírio Egídio Rodrigues, Fac. Engenh. Universidade do Porto, Porto, Portugal
Amalio Blanco Abarca, Universidad Autónoma de Madrid, Madrid, Spain
Angelo Antonio Agostinho, UEM, Maringá, Paraná, Brazil
Carlos Daghlian, UNESP, São José do Rio Preto, São Paulo, Brazil
Celia Regina Granhen Tavares, UEM, Maringá, Paraná, Brazil
Constantino Tsallis, CBPF, Rio de Janeiro, Brazil
Daniel Alexander Kuchma, University of Illinois at Urbana, Champaign, IL, United States
Dante Alves Medeiros Filho, UEM, Maringá, Paraná, Brazil
Doherty Andrade, UEM, Maringá, Paraná, Brazil
Edvani Curti Muniz, UEM, Maringá, Paraná, Brazil
Edvard Elias de Souza Filho, UEM, Maringá, Paraná, Brazil
Elisa Hatsue Moriya Huzita, UEM, Maringá, Paraná, Brazil
Ervin Kaminski Lenzi, UEM, Maringá, Paraná, Brazil
Francisco Carlos Teixeira da Silva, UFRJ, Rio de Janeiro, Brazil
Generoso De Angelis Neto, UEM, Maringá, Paraná, Brazil
Irena Lasiecka, Universit of Virginia, Charlottesville, United States
Jaime Edilberto Muñoz Rivera, LNCC, Petrópolis, Rio de Janeiro, Brazil
Jerry M. Bigham, The Ohio State University, Columbus, Ohio, United States
João Domingos Rodrigues, UNESP, Botucatu, São Paulo, Brazil
Joaquim Figueiras, Fac. Engenh. Universidade do Porto, Porto, Portugal
Jorge Guimarães da Costa Eiras, Universidade do Porto, Porto, Portugal
Jorge Luis Nicolas Audy, Pontifícia Universidade Católica do Rio Grande do Sul, Porto Alegre, R. Grande Sul, Brazil
José Galizia Tundisi, IIE, São Carlos, São Paulo, Brazil
José Teixeira Freire, UFSCAR, São Carlos, São Paulo, Brazil
Joseli Macedo, Pontifícia Universidade Católica do Paraná, Curitiba,Paraná, Brazil
Julieta Maria Pires António, Fac. Ci. e Tecnol. Universidade de Coimbra, Portugal
Kirk O. Winemiller, Texas A&M University, College Station, Texas, United States
Leandro E. (Steve) Miranda, Mississippi State University, Mississippi State, MS, United States
Liria Matsumoto Sato, USP, São Paulo, Brazil
Luciano Rodrigues da Silva, UFRN, Natal, Rio Grande do Norte, Brazil
Luismar Marques Porto, UFSC, Florianópolis, Santa Catarina, Brazil
Luiz Mario de Matos Jorge, UEM, Maringá, Paraná, Brazil
Marcelo Moreira Cavalcanti, UEM, Maringá, Paraná, Brazil
Marcos Antonio de Souza Barrozo, UFU, Uberlândia, Minas Gerais, Brazil
Maria José Rodrigues Faria Coracini, UNICAMP, Campinas, São Paulo, Brazil
Matilde Vicentini, Università La Sapienza, Roma, Italy
Mauro Luciano Baesso, UEM, Maringá, Paraná, Brazil
Mercedes Trentini, Fund. Universidade do Contestado, Concórdia, Santa Catarina, Brazil
Orlando Francisco Amodeo Bueno, UNIFESP, São Paulo, São Paulo, Brazil
Paulo Cesar Masiero, USP, São Carlos, São Paulo, Brazil
Paulo Milton Barbosa Landim, UNESP, Rio Claro, São Paulo, Brazil
Rafael Alves de Souza, UEM, Maringá, Paraná, Brazil
Raoul Henry, UNESP, Botucatu, São Paulo, Brazil
Renato Leão Rego, UEM, Maringá, Paraná, Brazil
Roberto Triggiani, University of Virginia, Charlottesville, VA, United States
Sr. Sérgio Roberto Pereira da Silva, UEM, Maringá, Paraná, Brazil
Proofreaders
Maria Dolores Machado, Revisora, Brazil
Normalizer
Adriana Curti Cantadori de Camargo, Normalizadora, Maringá, Paraná, Brazil
Gislaine Cristina dos Santos, Normalizadora, Maringá, Paraná, Brazil
Juliana Pimenta Delaroza, Normalizadora, Maringá, Paraná, Brazil
Liliane Tanamati Hundzinski, Normalizadora, Maringá, Paraná, Brazil
Staff
Edilson Damasio, Librarian EDUEM, Maringá, Paraná, Brazil
Edneire Franciscon Jacob, Fluxo editorial EDUEM, Brazil
Glauber Yatsuda, Suporte Técnico, NPD/UEM, Brazil
Luciano Wilian da Silva, Designer EDUEM, Brazil
Marcos Cipriano da Silva, Marketing EDUEM, Brazil
Marcos Roberto Andreussi, Publicação EDUEM, Brazil
Marcos Sassaka, Publicação EDUEM, Brazil
Monica Tanamati Hundzinski, Fluxo editorial EDUEM, Brazil
Vania Cristina Scomparin, Secretária EDUEM, Brazil
|
